1. How to use the grease gun:

Pull up the tail spring lever, rotate the lever handle, and fix the position. Open the head oil tank cap and fill up with butter. Cover the oil tank cap, screw it tightly, loosen the lever, use the nozzle of the oil filling gun to align the grease fitting, and press the oil filling handle repeatedly.

2. Matters needing attention

(1) Align and press the grease nipple at the front end of the grease injection rod on the grease nipple of the part that needs to be lubricated. Press the hand lever down close to the oil storage tank until it cannot be pressed down, and then raise the hand lever to the original position. position, then press down and lift up, and press the hand lever reciprocally to slowly press the lubricating grease on the parts that need to be lubricated. After filling the lubricating grease, pull out the grease gun.

(2) If the front end of the grease gun oil injection rod is inconvenient to be close to the oil injection part that needs to be lubricated, a hose should be placed on the oil injection rod, and the sleeve buckle should be fastened to prevent leakage of the lubricating grease from the sleeve opening. At the same time, Install a nipple and inner plug that matches the thread of the grease nipple on the other end of the hose, insert the inner plug into the grease nipple of the oil filling part, then tighten the nipple sleeve, and then add lubricating grease to the oil filling part according to the above method. .